admin October 17, 2019

Remove the belt from the carrier transport motor pulley. If the voltage is not present, replace the system board. If it is set in the printer driver to print in colour, and you are printing a mono black document it is only black and white if you are printing on white paper , the printer will request that you install the colour cartridge by flashing the leds , and achieve black print by overlaying the three colours. Just wondering if you managed to fix your Lexmark printer with an operating XP system? As other users, I have a mono cartridge installed and cannot change printing preferences from color buttons inactivated.

Uploader: Jukinos
Date Added: 25 November 2006
File Size: 13.18 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 13486
Price: Free* [*Free Regsitration Required]

Load paper into the sheet feeder.

Disconnect the carrier transport motor connector from the system board. Open the access cover. Electronics Page 56 Page 57 – Assembly 3: The carrier rail, which is not available as a FRU, is mounted in the elongated slots at the factory.

Electronics continued X Assembly 3: You saved me from buying a new computer and I had 2 unused cartridges that would have been wasted. Maintenance Station Problems Symptom Maintenance station: Hi, I discovered that the problem was the fact you had to change the cartridge!


Vintage Lexmark Color Jetprinter W/hardware – | eBay

Page 54 Page 55 – Assembly 3: If an error indicator appears, go to the error indicator table and take the indicated action for that error. Lexmsrk that your submission may not appear immediately on our site. Covers Page 52 Page 53 – Assembly 2: The page count and the error log do not change. Login or create an account to post a review. If the test fails, turn the printer off and disconnect CN5 from the colod board. During adjustment, the rail is pushed to the rear as far as it will go, before the mounting screws are tightened.

End-of-Form flag out of the sensor.

The test page prints the following lines. Seals the printhead when it is not being used to prevent the nozzles jetrpinter drying. Covers Parts Catalog Unlock the two printhead cable connectors and disconnect the printhead cable from the system board. General Information contains a general description of the printer and the maintenance approach used to repair it.

Remove the four small feed roller springs from the carrier frame.

As other users, I have a mono cartridge installed and cannot change printing preferences from color buttons inactivated. The Lexmark support page had me adding new ports, new drivers, etc.


Lexmark Color Jetprinter 1020 Windows XP

Parts peculiar to one or the lexmwrk of the assemblies are listed separately and identified by description. Remove the front cover. Diagnostic Aids Use these diagnostic test procedures to verify a repair. After you complete the repair, perform tests as needed to verify the repair.

Factory defaults are initially set to USA.

Lexmark Color Jetprinter Windows XP | FixYourOwnPrinter

General Information The user is directed, in the Printer Control program, to perform the bidirectional alignment adjustments after replacing a print cartridge. Initialize Error Log To run the test: Lexmark may use or distribute any of the information you supply in any way it believes appropriate without incurring any obligation to you.

Pages continue to print until you turn off the power or unplug the printer.

Don’t have an account?